Foxwell GT60 Plus Reset 2014 Range Rover Evoque EPB

The EPB red light appears on my 2014 range rover Evoque dashboard, which Foxwell diagnostic tool am I able to use to reset it?

Foxwelleshop.com engineer replied:

Foxwell GT60 Plus may be a good selection for you. It supports all systems diagnosis, full system active test, ECU coding, and tons of special functions like EPB, Oil light reset, DPF, TPS, ABS bleeding, etc. for quite 80 US, Asian and European vehicle makes.

It’s easy to use. Just follow the step-by-step guide below to try to.

Operation steps:

Connect GT60 Plus to the vehicle via the most cable properly, then operate the tablet.

Select “Maintenance”-> “EPB”

Read the instruction of Brake pad replacement on the screen and begin to try to 

Select Europe-> Land Rover-> Range rover Evoque-> 2014-2015-> hand brake pad replacement- Release to service position

Set the switch to on (position 2)

Wait for a flash for the system to stabilize

Note: System voltage battery voltage signal should be within the range of 12.5-13.5 volts. Ensure an approved charger is connected.

Then set the switch to off (position 0) and switch on again

Pay attention to the on-screen operator info and continue

Make sure the engine is running

Then read the important instructions as below

-Make sure the subsequent action has been taken

-Make sure the vehicle is stationary, on level ground which the pedal isn't depressed

-Chock wheels

-Make sure the vehicle cannot roll backward or forwards

-Release the hand brake 

When able to start the appliance, attend next step

The application will retract the hand brake pistons to permit the fitment of the latest restraint.

Test successfully

Then activate the ignition

Start clearing fault codes

When the fault codes are cleared, select “Parking brake pad replacement- Exit maintenance mode application”

Follow the prompt to show on the ignition, turn off…

Then read the Exit maintenance mode application instruction and continue

Make sure the engine is running

Read the related important instructions on the screen

Then activate ignition, turn off… clear fault codes till the method is complete

Source: http://blog.foxwelleshop.com/2014-range-rover-evoque-epb-reset-by-foxwell-gt60-plus/